ABC Firestop
Sealant 300mL



  • Intumescent
  • Fire Resistant
  • 4 hours Fire Rating
  • Paintable
  • Good Sanding Property
  • Flexible
  • Non-Toxic
  • Non-staining
  • Water based
  • Superior adhesion
  • Non-corrosive
  • Non-slumping
SKU: ABC-FRSS Category: Tags: , , , , ,

THE FIRESTOP SEALANT ADVANTAGE FIRESTOP SEALANT is a paintable, water-based, flexible acrylic joint and penetration sealant. It is specially formulated with high firestop solid components to effectively fill ducting openings, pipes and jambs where fire, smoke, toxic gasses and water may pass through. Prevent the spread of smoke and fire by using FIRESTOP SEALANT. Flames need oxygen to spread. Filling unwanted gaps with FIRESTOP SEALANT enables you to starve the flames from oxygen, which results in a delay of up to four hours. It is good to have added protection which FIRESTOPSEALANTcan give, so your family can safely sleep at night.




  • EN BS476 part 20:1987 (EN) European Standard


*Not intended for constant or permanent water immersion.

Note: Results shown are typical and reflect test procedures used. Actual field performance will depend on installation method and site conditions.



The surface must be fully cured & structurally stable . Make sure the surface is dry, clean and free from contaminants such as dirt, dust, loose material, oils and chemicals.

TIP: For cleanest possible result and a perfectly straight line sealant application, especially in hard-to-reach places, use masking tape. Apply the tape covering both sides of the line to be sealed, and then remove the tape before the sealant is dry.



1. Application a. Use a standard caulking gun to dispense the sealant. Note:The use of a caulking gun ensures even distribution for a professional finish.

TIP: Hold the sealant gun at an angle of 45° while pulling the gun towards yourself. Find the right working speed to properly fill the necessary gaps.

b. Ensure the sealant is in contact with both sides of joints and gaps. Use foam backer rods to establish good bonding at the sides and to control the depth of the sealant.

2. Finishing Remove excess sealant and tool with flat knife. Depending on humidity & temperature, applied sealant is touch dry after 30 minutes and can be painted over after 24 hours. Note: Protect from water exposure for at least 4 hours after application.



300ml cartridge

Store in a cool dry place. Firestop Sealant will remain usable one year from date of manufacture.


There are no reviews yet

Add a review
Currently, we are not accepting new reviews
Shopping Cart